|
Welcome to the Piano World Piano Forums Over 3 million posts about pianos, digital pianos, and all types of keyboard instruments. Over 100,000 members from around the world.
Join the World's Largest Community of Piano Lovers
(it's free)
It's Fun to Play the Piano ... Please Pass It On!
|
|
78 members (beeboss, brdwyguy, benkeys, Abdulrohmanoman, accordeur, Animisha, Anglagard44, 15 invisible),
2,099
guests, and
469
robots. |
Key:
Admin,
Global Mod,
Mod
|
|
|
Joined: Jan 2013
Posts: 141
Full Member
|
OP
Full Member
Joined: Jan 2013
Posts: 141 |
For simple monitoring, using some of the big VST samples like Ivory or Vintage D, and a laptop... Is it possible to get to 2 or 3ms latency?
I need a new laptop so I'm wondering what I need.
|
|
|
|
Joined: Mar 2007
Posts: 1,103
1000 Post Club Member
|
1000 Post Club Member
Joined: Mar 2007
Posts: 1,103 |
Are you using a high quality outboard sound card?
It's very important for better latency.
Take care,
Steve
|
|
|
|
Joined: Jul 2004
Posts: 6,703
6000 Post Club Member
|
6000 Post Club Member
Joined: Jul 2004
Posts: 6,703 |
This thread really should be in the Digital Piano section.
Yamaha AvantGrand N1X | Roland RD 2000 | Sennheiser HD 598 headphones
|
|
|
|
Joined: Jan 2013
Posts: 141
Full Member
|
OP
Full Member
Joined: Jan 2013
Posts: 141 |
Are you using a high quality outboard sound card?
It's very important for better latency.
Take care,
Steve Wasn't planning on it. Are there no laptops or current hardware built in that can give you an all in one solution? I want to keep gear to a minimum.
|
|
|
|
Joined: Sep 2003
Posts: 5,534
5000 Post Club Member
|
5000 Post Club Member
Joined: Sep 2003
Posts: 5,534 |
Are you using a high quality outboard sound card?
It's very important for better latency.
Take care,
Steve Wasn't planning on it. Are there no laptops or current hardware built in that can give you an all in one solution? I want to keep gear to a minimum. You really will get more activity on this question over at the digital forum. Most folks visiting this forum have instruments that don't need to be plugged in. ddf
Delwin D Fandrich Piano Research, Design & Manufacturing Consultant ddfandrich@gmail.com (To contact me privately please use this e-mail address.)
Stupidity is a rare condition, ignorance is a common choice. --Anon
|
|
|
|
Joined: May 2012
Posts: 7,439
7000 Post Club Member
|
7000 Post Club Member
Joined: May 2012
Posts: 7,439 |
Most folks visiting this forum have instruments that don't need to be plugged in.
Del, does that mean that you don't approve of Dampp-Chaser systems? - LOL
Marty in Minnesota
It's much easier to bash a Steinway than it is to play one.
|
|
|
|
Joined: Sep 2003
Posts: 5,534
5000 Post Club Member
|
5000 Post Club Member
Joined: Sep 2003
Posts: 5,534 |
Most folks visiting this forum have instruments that don't need to be plugged in.
Del, does that mean that you don't approve of Dampp-Chaser systems? - LOL I guess I should have said they "don't need to be plugged in to make piano-like sounds." If the Dampp-Chaser system is making sounds it's really in trouble. ddf
Delwin D Fandrich Piano Research, Design & Manufacturing Consultant ddfandrich@gmail.com (To contact me privately please use this e-mail address.)
Stupidity is a rare condition, ignorance is a common choice. --Anon
|
|
|
|
Joined: Mar 2007
Posts: 1,103
1000 Post Club Member
|
1000 Post Club Member
Joined: Mar 2007
Posts: 1,103 |
Actually, I have clients who use that software with their MIDI equipped acoustic pianos. Yes, you need an outboard card for it to work. Laptops won't do.
Take care,
Steve
|
|
|
|
Joined: Sep 2003
Posts: 5,534
5000 Post Club Member
|
5000 Post Club Member
Joined: Sep 2003
Posts: 5,534 |
Actually, I have clients who use that software with their MIDI equipped acoustic pianos. Yes, you need an outboard card for it to work. Laptops won't do.
Hopefully the pianos will still play without being plugged in. ddf
Delwin D Fandrich Piano Research, Design & Manufacturing Consultant ddfandrich@gmail.com (To contact me privately please use this e-mail address.)
Stupidity is a rare condition, ignorance is a common choice. --Anon
|
|
|
|
Joined: Jan 2013
Posts: 27
Full Member
|
Full Member
Joined: Jan 2013
Posts: 27 |
Using a standard, consumer-grade audio interface that is built into most computers will not achieve the performance you're after. You will need a professional-level audio interface with ASIO drivers to achieve the kind of audio performance you're talking about. Even then, you may not get down below 5ms.
Also, as you're playing sampled pianos, getting the maximum performance would mean having the samples located on a separate hard drive from the system drive and also having that drive be as fast as possible (i.e. 7200 RPM or more with a fast I/O and seek times).
H Weber 1963 Yamaha U3, Polished Mahogany (restored)
|
|
|
|
Joined: Dec 2012
Posts: 33
Full Member
|
Full Member
Joined: Dec 2012
Posts: 33 |
If using a laptop live for pianos be careful with some problems: - vibrations; can cause a hard disk failure or a freeze during a performance; - reliability; buy top of the line laptop with good I/O options (Firewire + USB); a lot of musicians use MAc's but a high end PC made for gaming is also a cheaper option; - tweaking the OS specifically for audio; forget internet, games, lots of processes running, etc.. Create a solid platform that you can rely on; use this laptop only for playing; - reading piano libraries; use two separate drives, one for OS and one for samples. If you can go with two SSD, they increase your laptop performance and speed and keep the heat inside way down; - use a good external audio device with balanced outputs; Finally... Be prepared for the worst and have a line out from your keyboard to the mixer. And have fun
|
|
|
|
Joined: Jan 2013
Posts: 486
Full Member
|
Full Member
Joined: Jan 2013
Posts: 486 |
some entry level audio interface offers 0ms direct monitoring.. like E-mu seires
otherwise 5ms is pretty hard to achieve especially USB causes delay.. a good PCMCIA interfaces cost a lot more... looking at 500-600$, the upper E-mu series..
PLEYEL P124
|
|
|
|
Joined: Jan 2013
Posts: 27
Full Member
|
Full Member
Joined: Jan 2013
Posts: 27 |
It should also be noted that the lower the latency you're pushing for, the smaller the buffer sizes and the more likely that you'll experience performance issues with your system (i.e. audio pops/clicks, drop-outs, etc.
If concerned about vibration and shocks to the hard drives, it might be best to consider solid state drives, which take the moving parts of a standard drive out of the picture, and also offer much faster performance. They are more expensive, though.
H Weber 1963 Yamaha U3, Polished Mahogany (restored)
|
|
|
|
Joined: Jan 2010
Posts: 283
Full Member
|
Full Member
Joined: Jan 2010
Posts: 283 |
I struggled for many hours trying to get my Windows machines to play well with VI's. Then a fellow on Piano World Digital forum said Apple products work with no problems. I bought a used Mac Mini and sure enough it worked right away. No latency, plug and play with all the VI's I have (Alicia's Keys, True Piano, NI Grand).
But then I bought an acoustic piano so my mac now sits idle:-)
Ed (Out in the West Texas town of El Paso) Yamaha P255
|
|
|
|
Joined: Oct 2008
Posts: 5,218
5000 Post Club Member
|
5000 Post Club Member
Joined: Oct 2008
Posts: 5,218 |
"...But then I bought an acoustic piano so my mac now sits idle:-)..."
Just as I fought down the impulse to say that an acoustic piano would meet the standard the OP wishes, with no costly and vexing additional equipment.
I told myself, sternly, that it was no answer at all... except, it is the answer. Or, an answer.
My impression is that many people think that latency under 10 ms is not noticeable; 6, 7, or 8 is thought acceptable. Anyway, I am curious about what E-Mu interfaces the other poster is referring to. I have the E-Mu 1616m, which is satisfactory if something of a bother, but it appears that Creative Labs has abandoned the product line, and has not updated the drivers or user interface for several years. Sweetwater no longer carries the line.
I know the OP's question is on the wrong forum, but since we've gone this far, I am curious about what E-Mu product is being referred to.
Clef
|
|
|
|
Joined: May 2009
Posts: 187
Full Member
|
Full Member
Joined: May 2009
Posts: 187 |
Agree about E-Mu. They are essentially dead (though who knows they could be reborn in the future).
I will also mention that Firewire is essentially a dead technology. I wouldn't be looking too hard for a laptop that has that as an option. USB2.0 has supplanted it as the more standard interface for professional interfaces. USB3.0 (Superspeed) which is available on most laptops today will eventually supplant USB2.0 sound devices while more exotic devices may go Thunderbolt. USB3.0 is supposed to be backwards compatible with 2.0 but many audio vendors have problems running their USB2.0 devices on USB3.0 ports (caveat emptor).
Regarding 5ms, yes you can get there pretty safely but as others have mentioned not without a decent interface. You can even get to 2ms though you might suffer occasional dropouts. Look to RME or Roland {Duo/Quad/Octa}Capture. But be prepared to drop some real dough.
The comment of "0ms monitoring" (usually marketed as "zero latency monitoring" since it is not truly 0ms) is a pro pos of nothing and means the interface can turn a mic or line input going into the device and mix it with audio/sound out of the computer/software. When you are talking triggering sounds in a software engine latency is the addition of input latency (from MIDI or virtual USB MIDI) plus outbound buffering latency.
Regarding fast harddrives, depending on the software and the sample set used you might be better served upgrading your memory to 16GB than shelling out $300-$500 for a secondary drive. You definitely do not need a secondary SSD since most if not all of a sampled instrument can be loaded or cached into RAM unless you had *really* large samples (sampled at 96K). That said, SSDs can do wonders to improve the overall efficiency and speed of your machine. Personally though, if I were to put an SSD in my laptop, I'd put it on the system drive where the pagefile/swapfile is located.
Regards, Ryan
|
|
|
|
Joined: Jan 2013
Posts: 141
Full Member
|
OP
Full Member
Joined: Jan 2013
Posts: 141 |
I ordered the HP 8560plaptop, which has a 160gb SSD drive.
I also have an old Emu 1616m with PCMCIA connector. Not sure if that will even work ok with an adaptor for the Expresscard connector on the 8560p.
Regardless, I was able to dub over guitar tracks with my Emu years ago setting it at 5ms latency. But the big VST are definitely more demanding.
|
|
|
|
|
|
Piano
by Gino2 - 04/17/24 02:34 PM
|
Piano
by Gino2 - 04/17/24 02:23 PM
|
|
Forums43
Topics223,405
Posts3,349,434
Members111,637
|
Most Online15,252 Mar 21st, 2010
|
|
|
|
|
|